The first switch panel was great as a mule to test the system but it didn’t match the upper panels so it’s time to make a new design that works better with the upper panels. Once I have finished this i need to make a flip-up cover to give access to the panel and make…
Tag: electric
WIP lights
Finally got lights connected to the handlebar switches… after having to acquire an homologated headlight. Still a query on the rear amber lights might need to move them further back. TBH, I mainly made this post because I like making GIFs
Not pretty, but she’s a running
So, the basic powertrain of the battery, BMS, controller and the motor have been completed, or as much as they can be for now, and….. xj600e is alive and running under at full power of 100ah (charge socket works too). I am happy to see it finally work TBH. I had a couple of issues…
Power cable–ing
Spent some time power cable–ing. I have managed to route the 12v, hall sensor cables, and power cables after making a new gland bracket to hold the V/W/U motor cables. Need to do some tests before firing it up. The last test used 48v on the connector. It should use 12v, technically, so I will…
Contactor
1Kohm/10W resistor that straddles the main contact to pre-charge and protect the controller on voltage in-rush is needed on this contactor, without this the contactor poles would spark & arc. A 200V/3A diode is also needed across the coil to suppress the high voltage spike that will happen when disconnecting the power. Both these components…
Battery BMS stuff
I have quickly realised that the triumph of 1st wheel motion is momentary. Next on the list of things to complete is the battery BMS so I can charge the battery. I have no mains power supply so this is important to do quiickley so I can keep the wheel spinning. The Nissan leaf busbar…
Tuning #1
Have spent the evening calibrating the 8kw QS V3 motor. Out of the box the motor was a but rough because the controller and the motor are not from the same supplier this is normal apparently. Watching the hub motor robotically rotate with beeps and jerks as it Identifies the angles of motor using the…
Wiring…
Okay, time to make a start on the cable loom for XJ600e, finally. Bit of a boring post but an important one because once all is sound with the wiring then finally the panel design can start with the assurement that the packaging for the powertrain is concrete. This means less changes to the final…
Isolator carriage v2 printed
I know I should be used to it by now (after all I see it happens all the time in University and in the design industry) but it still amazes me that I can print designs into reality that only exist on a computer. Anyway, I managed to push out a rough print overnight to…
Isolator carriage v2
Have made some changes to v1 design of the isolator carriage. A bit more cable management and some amendments to the BMS to ensure the charge input cables are orriended correctly, etc. Need to print the design to double check it maybe get some advise of the management of the cables. Currently the high and…
An electrifying life on two wheels... 