Swingarm brake mods

Have spent a bit of time finishing the rear brake caliper; removing the inside slot brackets and fixing. Also swapped the brake to the right side of the bike to help clear the hydraulic banjo. Still need a new rod, as because I am using the old linked aluminium thin rods. The clevis used was pinched from a pneumatic set-up from a control panel so this will also need to be replaced. Would be nice to replace the rose joint for a clevis end.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s