Swingarm shock mount

The original mount from the Showe shock was redundant because it used a new M12 12.9 grade bolt that fits the frame. With a needle bearing (OD22 x ID16 x L22mm), Bronze Oilite Bearing Bush (ID12 x OD16 x L25mm), copper washers (ID12 x OD16 x L1.5mm), and some 16mm 3mm section oil seals a make shift mount will hold it in place. This will be add hardness to the ride though. A rubber-metal bond bush mount has been sourced so if it is too hard then it will replace the bearing mount.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s